Contact Forum Editor

Send an email to our Forum Editor:

PLEASE NOTE: Your name is used only to let the Forum Editor know who sent the message. Both your name and email address will not be used for any other purpose.

Networking Help

It's free to register, to post a question or to start / join a discussion

View Forum Rules | Contact Forum Editor

 

how to used command from cmd shutdown /i/:/s

ORANGAN

Likes # 0

Posted December 8, 2012 at 11:48AM

HEllo,I am from Russia an speak English not best, by I try to tell so, that you could understand me. Please help me understood, how to used command from cmd shutdown. I try to power of computer in my own home network. I used command in cmd shutdown /i/:/s. I enter ip address pc with I wont to power off. But in result a take that: 10.10.0.3: refused access.(5) One men said that I must used telnet or terminal access, a include my pc in domain by I don’t know how done it.

Like this post
mgmcc

Likes # 0

Posted December 8, 2012 at 7:34PM

To power off a remote computer with the IP address 10.10.0.3 open a Command Prompt window and run the command:

shutdown /s /m \\10.10.0.3

Like this post
GoldMen

Likes # 0

Posted December 17, 2012 at 6:49AM

I am really hard try, that you could understand me. Please told me, if somebody to know about protocol BGP in Windows 7,was it protocol in windows? If yes, so how can I set up it protocol?

Like this post

Reply to this topic

This thread has been locked.



Check out PC Advisor's other tech forums

Send to a friend

Email this article to a friend or colleague:

PLEASE NOTE: Your name is used only to let the recipient know who sent the story. Both your name and the recipient's name and address will not be used for any other purpose.