It's free to register, to post a question or to start / join a discussion
Device Driver Problem or Hardware?
Likes # 0
Posted August 20, 2011 at 3:11PM
My PC is a Dell XPS 420 running Windows Vista Home Premium (Service Pack 2) with all available Windows updates. I have also a Dell Studio 1555 laptop running Windows 7 Home Premium (Service Pack 1), and an Epson Stylus Photo PX720WD printer. Even when the laptop is within feet of the D-Link wireless router the network connection frequently fails and my network does not show up although those belonging to neighbours do. Most of the time the PC will not connect to the printer and neither will the laptop when the connection drops out. However, when the PC is switched off and I start up only the router and the laptop, the signal strength from the router is at the maximum and the laptop has no difficulty connecting to the internet but it does lose connection to the network as soon as I try to send a document to the printer.
In the PC’s Device Manager under “Network adapters” the following are listed:
Intel(R) 82566DC-2 Gigabit Network Connection
Microsoft 6to4 Adapter #2
and all except the Intel(R) 82566DC-2 Gigabit Network Connection have yellow exclamation marks next to them.
Starting at the first 6TO4 Adapter I have clicked on Update Driver Software and each device, down to and including Microsoft 6to4 Adapter #2, is reported to have the best driver software already installed and up to date. However, clicking on Properties on every device gives “This device cannot start (Code 10)” and clicking on “Check for solutions” informs me “Could not load driver software”.
Further down the Device Manager list under “Sound, video and game controllers” is “IDT High Definition Audio CODEC” and this also has a yellow exclamation mark next to it. Each time I boot up the PC the message appears “Found New Hardware – IDT High Definition Audio CODEC” and Driver Software Installation starts automatically but fails. “Sound” in Control Panel says “No audio devices installed”. This is a mystery as the sound worked perfectly well until quite recently and I have not made any changes.
I am at a complete loss to know what to do or where to go next.
Likes # 0
Posted August 20, 2011 at 4:31PM
6to4 adapter is a component used for transmitting IPv6 packets trough IPv4 network correctly.
In some scenarios, there will be a code 31 or code 10 error appearing beside this component. A possible reason is, the network adapter doesn’t support this feature. You may update the driver for your network adapter or chipset, and then try to uninstall and reinstall the this component.
To uninstall the component, right-click the item in Device Manager and select Uninstall.
To reinstall the component, in Device Manager, Action – Add Legacy Hardware – Next – “Install the hardware that I manually select from a list” – Network adapters – Microsoft – Microsoft 6to4 Adapter – Next – Finish the wizard.
If the steps above doesn’t solve the problem, your network adapter is not a supportive one for this component. You can completely ignore this error, if there isn’t IPv6 network deployed in the environment. The error won’t affect your system.
To remove the error message, please right-click the Command Prompt and run as administrator, type the command netsh in 6to4 set state disable, press Enter. The component will be disabled and hidden.
Reply to this topic
This thread has been locked.