It's free to register, to post a question or to start / join a discussion
Hard or Soft problem?
Likes # 0
Posted June 8, 2011 at 3:06PM
Hi XP suddenly didn't see my ATI 4850 drivers on a cold start, reverting to 16 colour 4bit, I re-loaded the ATI drivers (from disk). MacAfee was also damaged (showed on Task Bar but failed to run) but re-installing has resolved this. MacAfee found Spyarcade (removed) and AMB found PUM Disabled Security but this may well be MacAfee turning them off in favour of itself. So now it either boots -
(2) Correct resolution but doesn't see my ATI card and my Asus temp and fan monitor program loads but with two displays.
(3) It run 16 colours 4bit again. However, MacAfee continues to load and run ok now on each of the above (3).
In addition to MacAfee (Internet Security) I also use Malwarebytes and Spybot - neither run in resident memory. No new soft/hardware/modifications have been done recently.
I've moved forward since this started a few days ago but now I'm not sure if this is a faulty video card or software fault or an attack that's sneaked in under the radar - help!
Likes # 1
Posted June 8, 2011 at 3:14PM
Maybe Graphics card driver needing updated.
Have you had a look in device Manager to see if there are any yellow exclamation marks beside anything.
Likes # 1
Reply to this topic
This thread has been locked.