Best phone camera 2016/2017: Galaxy S7 vs iPhone 7 vs Google Pixel vs HTC 10 Evo vs OnePlus 3T vs…
I am looking to setup a Wireless network on 2 PC's using Telewest Blueyonder Broadband.
Could somebody please answer the following questions.........
1) What Hardware will I require and any suggestions/recommendations
2) How easy is this to do...?
3) What gateways/ip's do I need to enter.
Both PC's will only be used for general webrowsing, nothing spectacular.
Do you want both PC's to operate wirelessly or can you live with one wired?
I am trying to use both wirelessly...The 1st PC works but the 2nd won't connect to the web etc?
To create a wireless network for Internet access and File/Printer sharing, you have essentially two options:
1) Install a Wireless Network Adapter in each PC and create an “Ad Hoc” Wireless Network. This is a network in which the two PCs talk directly with one another, rather than via a Wireless Access Point. “Internet Connection Sharing” is then enabled on the actual Internet connection in the “host” PC and the “client” PC will have Internet access provided the “host” is running and online.
2) The preferred option for connecting more than computer is to use a broadband Router. This is an ”Infrastructure” wireless network because the connected PCs communicate via the router’s Wireless Access Point. Again, a wireless adapter is installed in any PC that needs to connect wirelessly, but often the main PC is close enough to the router for it to use a “wired” connection with only the remote PC connecting wirelessly.
With “Internet Connection Sharing” under option (1), when you enable this on the Internet connection, it automatically configures the Local Area Connection with the IP address 192.168.0.1 and subnet mask 255.255.255.0. However, as you will be using a WiFi adapter, you want this address to be allocated to it, rather than a “wired” Ethernet adapter if you have one fitted, so the Local Area Connection should be disabled before setting up “Internet Connection Sharing”. Also, if you run the Zone Alarm firewall in your “host” PC, the Internet Zone Security level must be reduced from High to Medium or “ICS” traffic will be blocked. The "client" PC's WiFi adapter should be set to get its IP address automatically, which it does by DHCP from the "host" PC.
With a router, as in option (2), it is the router which connects directly to the ISP and not one of the connected PCs. The router in turn allocates the IP addresses to the PCs, using one of the address ranges reserved for Local Area Networks, usually 192.168.xxx.xxx
Either of these options will additionally allow you to run File and/or Printer Sharing wirelessly across the network.
If you are running software firewalls, the IP addresses of the networked PCs must be put into its "trusted" area to allow them to communicate with one another.
This thread is now locked and can not be replied to.