sata with ide

  eutrucker 10:03 14 Dec 05
Locked

Is it possible to mix a sata hard drive with a IDE hard drive and if so which one would be better to install windows xp on, for some reason am doing this but system dont seem to recognise sata drive.

  PsiFox 11:50 14 Dec 05

when you install xp on a sata drive at the beginning of the install you will notice a message "press F6 to install Raid or other drivers". At this point you will need to insert afloppy containing the sata drivers copied from the motherboard CD.

All should be fine then.

You will be able to use both sata and ide if you configure your bios correctly.

  Fruit Bat /\0/\ 16:18 14 Dec 05

Installing XP on SATA drive
Once you have the drive(s) connected you are ready to start installing XP.
Master and Slave
Remeber since it's serial you can only have one device per SATA port/cable so SATA drives don't have jumpers. On the Motherboard SATA1 Port is for the primary device, SATA2 port is for the secondary device etc.
SATA controller driver
Your Motherboard or SATA controller card requires a driver to work properly. If you did not get a Floppy Disk with the SATA driver included with your Motherboard you will have to make one. The SATA drivers can be located on the installation CD that came with your Motherboard or preferably, download the latest SATA controller drivers from the manufacturers site. Once you have located the drivers copy them to a formatted floppy disk. Make sure they are in the root directory i.e. not contained within any folders.
BIOS settings
When you turn on the PC hit the Delete key when prompted and you will enter the BIOS (Basic Input Output System). Here you set the first boot device to be the CDROM drive, the option is usually found under the Advanced Options section but this depends on your BIOS and you may have to look around for it. Once you have done this save and exit.
Installing the SATA controller driver
Once you have set the PC to boot from the CD make sure the XP CD is in the CD drive and start the installation as per usual. Within the first minute or so of the installation Windows will prompt you to press F6 to install RAID or SCSI drivers, do this. Windows will continue to install then ask you to locate the driver. now with the floppy disk created earlier in drive A: select the driver and hit Enter.
With the SATA drivers installed you can now continue the Windows installation as usual.
BIOS settings revisited
Once Windows has finished installing you will need to make sure the PC is set to boot from the SATA drive. To do this make the first boot device SATA if the option is available.If not you have two options: HD0 - If there are no IDE HDs present, or SCSI if you do plan on running an IDE HD as a secondary device.

This thread is now locked and can not be replied to.

AMD Ryzen release date, specifications and features: Three CPUs from the Ryzen 7 range now…

1995-2015: How technology has changed the world in 20 years

How the painting-like animated sequences in A Monster Calls were created by Glassworks Barcelona

Best iPhone games 2017 | Best iPad games 2017: 162 fantastic iOS games that you need to play right…