Hi there! I have an ehome router which I used before with other computers in a different country. Now, I moved out so I want to use it again but with other computers, so the address is different. I tried to set it up, everything is going on well, all the lights are lit, but when I try to set it (that is, to go to the setup wizard, with the ip 192.168.0.1), “the page cannot be displayed”. Can you tell me what the problem is and how I can solve it? Does this mean that if I already used and set up the router once, I cannot set it up again? Thanks!
new info: First: if i connect my routr to my modem all the lights in the router( power,status, wan, wlan, local network 1) are lit and on the modem: cable activity, cable link, pc link and internet are lit.
second: if I go to start/ run/ cmd and type ipconfig/ all i get the following message: Ipconfig is not recognized as an internal or external command operable program or batch file.
tried this ip as well..it is not working:(( dunno what else i could do?!? i mean, after I connect the router to the modem and computer, all i have to do is open my browser and type the router ip address, right? and normally, there should be an admin and password window, right? but"the page cannot pe displayed"...is there anything else that i have to do and i haven't done?!
Check in Control Panel - hardware - device manager that your ethernet card is ok - no yellow triangles or red crosses. Then - control panel - network connections - the ethernet connection should be listed - right click - properties - select tcp/ip - properties - set to obtain ip address automatically and dns automatically. Also in the browser window select tools - and ensure there is not a tick next to work offline. When you plug the ethernet cable into the pc it should obtain an ip address automatically - if it doesnt then there is usually an icon that says limited connectivity.
If your Router's IP address is 192.168.0.1, it may be necessary to configure your "Local Area Connection" manually with an IP address in the same Subnet (IP address range), in order to access the Router's setup pages if it isn't getting its address automatically by DHCP. Use something like:
IP address 192.168.0.5 Subnet Mask 255.255.255.0
>>> if I go to start/ run/ cmd and type ipconfig/ all >>> i get the following message: >>> Ipconfig is not recognized as an internal or >>> external command operable program or batch file.
The command is IPCONFIG /ALL with a space between 'ipconfig' and the forward slash.