No display on Monitor (Stays in Stand-by Mode)

  The Mad Monk 20:28 11 Aug 04

On my other PC the when it is started up no display appears on monitor. It stays in Stand-By Mode so it would appear that no signal is getting there or being received correctly. Have tried PC on 2 working monitors and no joy. Have also tried changing AGP Graphics card and still no joy. I now think this is a MB fault but before I rush out and buy one I am asking your advice and opinions.

Lights on PC seem to power up as normal.

  Diodorus Siculus 21:38 11 Aug 04

Do you have on board graphics? If so, go into bios and switch to that.

Or have a look in the bios and see what is there. Also make sure that the graphics cards are fully seated.

  Lady Lara 22:03 11 Aug 04

Mobo does not have 'On Board' Graphics and as no monitors work with it I cannot check BIOS settings.

  son-of-a-gun 22:13 11 Aug 04

I had the same problem not even POST MB, had past away.

  SEASHANTY 00:27 12 Aug 04

Are you not getting any bios beeps? Could be a failed graphics card but if so I would expect some
bios beeps at boot up. Also check the pins on the SVA D-dub plug. A slightly bent pin can prevent the
output to the monitor.

  SEASHANTY 00:29 12 Aug 04

That should be the SVGA plug.

This thread is now locked and can not be replied to.

Surface Pro (2017) vs Surface Pro 4

20 groundbreaking 3D animation techniques

How to mine Bitcoin on Mac