No beep on new mobo

  Taw® 19:09 05 Nov 04
Locked

Just fitted a new mobo expo cu133 and PIII 1.13. have set switch as shown in manual but on booting all I get is power, no boot sequence or beeps. Am I missing something really easy, or how would I know how to go about troubleshooting?

I would check the ram is seated properly--usually the problem with no beeps.
Failing that you should clear cmos and try rebooting [instructions to clear cmos will be in mobo manual ]

hope that helps.

  Dorsai 19:24 05 Nov 04

An AGP card that has not seated fully can also give this problem. So double check it has gone all the way in. AGP slots on new Boards can be really very stiff to insert the card into.

  PA28 20:04 05 Nov 04

Have you connected your speaker to the right pins?........

  Taw® 20:19 05 Nov 04

Have tried your suggestions folks but no joy. My PIII is a tualatin the ad for the mobo said it would support it, but the manual just says for coppermine, I think it may be a case of trying an ordinary PIII

This thread is now locked and can not be replied to.

Nintendo Switch review: Hands-on with the intuitive modular console and its disappointing games…

1995-2015: How technology has changed the world in 20 years

This abstract video touches on division in our technologic world

Best alternatives to iTunes for Mac | Best music players for macOS: Free your music from the…