Qualcomm Snapdragon 835 benchmarks: Antutu, Geekbench 4, GFXBench and PCMark results
Can anyone help me? I have just purchased a new ASUS P5LD2 motherboard, and while setting it up, I find in the manual that I can use an S-ATA drive as a boot disk, but the important notes section says I must install XP Service Pack 1 or later before using S-ATA drives!
How can I use the S-ATA drive as a boot drive, if I have to install XP first?
I have two 250GB S-ATA drives, and two IDE drives (one x 250GB and one x 120GB) to use with the board.
If anyone can help I would be greatly obliged.
Installing XP on SATA drive
Once you have the drive(s) connected you are ready to start installing XP.
Master and Slave
Remember since it's serial you can only have one device per SATA port/cable so SATA drives don't have jumpers. On the Motherboard SATA1 Port is for the primary device, SATA2 port is for the secondary device etc.
SATA controller driver
Your Motherboard or SATA controller card requires a driver to work properly. If you did not get a Floppy Disk with the SATA driver included with your Motherboard you will have to make one. The SATA drivers can be located on the installation CD that came with your Motherboard or preferably, download the latest SATA controller drivers from the manufacturers site. Once you have located the drivers copy them to a formatted floppy disk. Make sure they are in the root directory i.e. not contained within any folders.
When you turn on the PC hit the Delete key when prompted and you will enter the BIOS (Basic Input Output System). Here you set the first boot device to be the CDROM drive, the option is usually found under the Advanced Options section but this depends on your BIOS and you may have to look around for it. Once you have done this save and exit.
Installing the SATA controller driver (if not built into Bios)
Once you have set the PC to boot from the CD make sure the XP CD is in the CD drive and start the installation as per usual. Within the first minute or so of the installation Windows will prompt you to press F6 to install RAID or SCSI drivers, do this. Windows will continue to install then ask you to locate the driver. now with the floppy disk created earlier in drive A: select the driver and hit Enter.
With the SATA drivers installed you can now continue the Windows installation as usual.
BIOS settings revisited
Once Windows has finished installing you will need to make sure the PC is set to boot from the SATA drive. To do this make the first boot device SATA if the option is available. If not you have two options: HD0 - If there are no IDE HDs present, or SCSI if you do plan on running an IDE HD as a secondary device.
Thank you very much for your advice - It appears to have worked, as my system is booting from the SATA drive.
for future reference
Please post your replyies in the box below so everyone can se and add help as required.
Glad your sorted, please tick resolved box
This thread is now locked and can not be replied to.