Mounting a Motherboard

  Mo H 17:05 25 May 04

My new case has raised circular (molehill type) screw ports which motherboard sits neatly on. Do I need any other bits to fix it on like the raisers we see on old cases?

  Indigo 1 17:07 25 May 04

It depends on the outputs at the back of the case really.

If they line up with the hole in the case then no.

  hugh-265156 17:08 25 May 04

you always need to use stand offs or it will short

  Mo H 17:11 25 May 04

Yes the outputs line up. However, I now have a contradiction. Will it short, is it OK?

  Indigo 1 17:14 25 May 04

You should use the paper washers to prevent shorting.

  Indigo 1 17:15 25 May 04

Use some fibre washers to prevent shorting under each mounting point.

  hugh-265156 17:21 25 May 04

"Will it short, is it OK?"

if metal is touching metal then yes it will short.

as Indigo 1 says you could use plastic or rubber washers to stop this from happening.

you should really have got some stand offs included with your new case and if you did not i would buy some as they will lift the mobo up and allow a bit of air to circulate behind the mobo.

very cheap to buy.only cost a few pence.

  Mo H 17:33 25 May 04

Will buy some 'Stand Offs'

Thanks everyone.

  Satmansq 17:36 25 May 04

Before you buy stand offs, if all the ports line up then you just need non conductive washers and stand offs will mean ports dont line up.

  Mo H 17:38 25 May 04

so basically plastic washers then?

This thread is now locked and can not be replied to.

Surface Pro 5 News - release date, UK price, features, specs

Gear VR vs. Daydream: Which delivers the best VR experience?

iPad Pro 12.9 vs Surface Pro 5