maybe a power problem

  neilbentley 14:26 PM 09 Mar 12

Hi, I have a HP Pavilion on windows 7 (64) with 6gb RAM. I replaced the graphics card with a 9800GT a while ago (only have the original 300w power supply) ran with no problems. recently I added a second monitor and have since had problems with graphics during gaming. The graphics seem to slow down and miss frames for about a minute, occasionally, then picks up again. I thought it might be the graphics card or the motherboard. Have just read the another thread that advised what power would be required if they upgraded to a 900GT.

Would my problem be more likely that I dont have the power available, and that when another system starts up it slows affects the graphics??

If I do need another power supply, is it easier to replace the box and transfer the inards or just the power supply, the existing PS does seem to be welded into place?

Any help/advice would be great, thankyou

  johndrew 15:26 PM 09 Mar 12

Your PSU will be retained with four screws through the rear panel similar to this photo.

A 300W PSU sounds small for what you are trying to achieve. Use this PSU calculator to find the capacity you should be using. I think it should be nearer 450W.

  northumbria61 15:32 PM 09 Mar 12

I would definitely say that a 300w power supply is not enough for your setup. It is always better to have more than less. I am not a gamer and I don't have two monitors and I have a 600w PSU.

I doubt that your PSU is welded in. They are usually held in place by 4 self tapping screws from outside the case. Look for a higher wattage PSU but with the same size (dimensions) as your current one.

If you need further advice re: make, supplier etc. post back here and I am sure someone will have a recommendation for you.

  Fruit Bat /\0/\ 15:57 PM 09 Mar 12

If renewing a PSU check:

  1. The physical size of your PSU, some are hard to replace due to being a non standard size.

  2. The amount of power need from the PSU don't skimp.

  3. The correct connections for your equipment

1. Physical Dimensions

Besides the specs and form factors, the physical dimensions are also important factors in selecting a compatible power supply. Here is an outline of the physical dimensions of most standard power supplies:

ATX: 6x3.5x5.5", HxWxD. Most common. Uses 4 mounting screws.

Mini-ATX: 5x3.5x5", HxWxD. Rare size. Uses 4 mounting screws. Can be used in a regular ATX case, but often not the other way around.

MicroATX: 5x3x4", HxWxD. Use 3 mounting screws. Not interchangeable with ATX or miniATX.

Flex ATX: Even smaller than Micro ATX. Various sizes according to case specs; often not interchangeable.

Use the data above to determine if a particular power supply would fit your case.

The quality of a power supply can be estimated by its weight. While this is not a true scientific or thorough measurement of the power supply reliability, it is nevertheless a very simple and easy way for ordinary PC users to estimate and compare the quality of a power supply. Why weight matters

2. Power supply calculator

3. Correct connections Some boards have 20 pin connectors others 24 pin There is often a 4 pin plug required to power Intel CPUs Molex D plugs for IDE HDD and CD/DVD drives SATA power connections for latest HDDs and DVD drives.

Guide to changing PSU

  neilbentley 18:43 PM 16 Mar 12

Hi, Upgraded the PSU to a 750 watt. And I still get the same problem. every 10 mins playing COD the graphics and mouse movements slow down for about 1-2 mins then is fine again for another 10 mins or so. Times are approx. They are not the same each time but near enough!!! It's almost like the frames per second go to about 1/2 what they should be. Any ideas?

  KRONOS the First 19:16 PM 16 Mar 12

I am thinking that it might be a over heating problem with your graphics card. Do you have similar problems when not gaming? Which COD are you playing? Is it the latest one? 9800gt is still quite an old card by today's standards though I have no doubt that it will play the game but not on high settings. Are you using the latest drivers for your card not the ones that came on a disk with the new card.

  neilbentley 09:45 AM 17 Mar 12

hi Chronus, its worse when gaming, it is MW3 the latest one. but it also does it on any other game!! I also use Autocad which is high end graphics. It occasionally does it then too, but to a much less degree. I do have the latest drivers, for everything!! updates are pretty much automatic. If I were to get a replacement graphics what card could you recommend, I have always had Nvidia. Wouldn't want to spend too much though, £120 ish.

  robin_x 10:05 AM 17 Mar 12

Might be an idea to check temps before another purchase (unless pretty sure).

Core Temp and Speedfan apps report PC temperatures.

I only have on board graphics, so don't know if they can see graphics card temperature(s).

  neilbentley 10:12 AM 17 Mar 12

I have a suspicion the card is on the way out, my second monitor sometimes becomes looses signal, just goes black! If I try to detect it I can't. I usually have to do a reboot or pull the cable out and reinsert it.

  carver 10:18 AM 17 Mar 12

Have a look here for some ideas about graphic cards Tom's Hardware give you an idea of the sort of card to get.

Sounds like your card is overheating so might be an idea to give it a clean before buying a new card, invest in a bottle of compressed air and give everything a good blow out.

  carver 10:24 AM 17 Mar 12

Sorry about this but I have just noticed that you mentioned you had 6GB of memory, HOW have you done that.


This thread is now locked and can not be replied to.

Sony Vaio Z Canvas release date, price and specs: Another Surface Pro rival but for the US

1995-2015: How technology has changed the world in 20 years

Steve Albini's notorious email is now a punchy music video

Live Photo tips: How to take Live Photos on the iPhone 6s, how to view, share, edit and find Live…