hard drive

  marbles 11:06 25 Aug 08

As sad as it may seem, but i was watching my computer boot up and noticed that my only hard drive was set to Slave, worked o.k and have now set it to master. Only need to know if that would have affected performance of my p.c.

  Technotiger 11:13 25 Aug 08

As it is your only hard drive, I doubt that performance would have been affected, but it is best to have it set as Master anyway.

  Technotiger 11:15 25 Aug 08

You may find this interesting reading ... click here

  DieSse 11:58 25 Aug 08

One point in the link that is not entirely clear.

If only one drive is on an IDE cable, it should always be attached to the end connector. This is to minimise electrical "noise" being picked up on the unconnected end piece of cable - as it acts as an aerial.

This has nothing to do with where Master and Slave are on the cable - if there's two drives, set with Master and Slave jumpers, they can be in either position on the cable.

Only when using both drives with Cable Select does the cable itself determine that the end drive is the Master and the drive on the middle connector is the Slave.

This thread is now locked and can not be replied to.

Nintendo Switch review: Hands on with the intuitive modular console and its disappointing games…

1995-2015: How technology has changed the world in 20 years

Here's what should be coming to Adobe Project Felix in 2017

Best iMovie for Mac tips 2017 | How to edit video with iMovie: 26 brilliant video editing tricks…