extend range

  reclaimjack 01:03 10 Dec 05
Locked

hi again ... as some of u will know i have a 3com 11g wireless router which goes to a 3com hub ..which conects to my print an file server... the network and everything is fine... but if i want to extend the range of my wireless conections and i have two more routers the same as the first one... can i config it all so i run 2x 50 foot cat 5 cables out of the hub to the extra 2 wireless router's and drag the wireless signal back to the first one...i also have linksys (cisco)rv082 vpn router which i wish to replace the 3com hub with(more wired connections).. i know how to config this to be a hub but i want to basicaly set each router 50-60 foot apart and thus throw my signal 60ft from each router...and i then hope if all goes ok it all runs 300 to 400 yrds from the first access point is this poss or am i daft ????? cheeres all

  reclaimjack 01:23 10 Dec 05

r3
/ / / adsl---><- ----x--hub---x-------r2
\ /
\ /
\ /
\ /
r1

  reclaimjack 01:25 10 Dec 05

that worked i just mapped it with // & --- but it all went left

This thread is now locked and can not be replied to.

Huawei P10 review

1995-2015: How technology has changed the world in 20 years

An overview: What leading creative agencies are doing to improve diversity

New iPad, iPhone SE & Red iPhone 7 on sale now