epson stylus 880

  widdy 22:33 11 Dec 05
Locked

After long service my printer suddenly refused to print and all 3 LEDs on front started to flash. indicating low ink and paper out. both not true.

Using compatible cartridges but never been a problem before.
Any help appreciated.

  SANTOS7 22:46 11 Dec 05

Uninstall/reinstall device update drivers from link
click here

  Fruit Bat /\0/\ 22:55 11 Dec 05

This for a C40ux but the princile is the same.

Problems with my Epson C40UX printer, the red and green light began flashing and a window popped up, saying, take it to your services center because some parts have reached the end of their life.

Printer companies set a “protection counter” on all printers , it’s an internal counter measuring the amount of ink wasted by head cleaning.

Reset the "protection counter" as well as clean the “waste ink pad overflow”.

1. Unplug the power and USB cables from the printer. Pry open the C40UX printer, careful not to break anything. Use a flat blade screwdriver to pry it apart; there are two-three tabs at the back and two at the front. Gently push them in, and then using a bit of force pry apart the cover.

2. Next remove the two (2) waste ink pads. They are located at the back on the left hand side. I used the flat blade screwdriver to lift up the ink pads (they were soaked). Please use rubber gloves as it gets very messy.

3. Next wash them with just plain hot water until they are white again. I just let the hot water run on them (the pads are about three inches long).

4. Once washed dry them using a hair drier. (you could place it the sun for a few hours or on top of your heater or maybe in a heated oven; (make sure you do not set it on fire with too much heat).

5. Once dried place the pads back in the ink waste bin at the back of the printer.

6. Closed the printer cover and put back all the pieces and plug in the USB & power cable and turned it on. (Yes the lights are still flashing).

7. Go to this link and download this software: click here

8. Install the software and run it.

9. Select your printer and model number ( It only says C40 there is no UX, choose it anyway). It will ask if you replaced with new pads; say “YES”. Then close the window.

10. Now right click on the SSC service utility, it looks like a printer icon near your clock in the task bar.

11. Then click on reset counters. You can do all other stuff with this utility too.

12. Turn off the printer power and then turn it on again. If necessary un-plug the power cord from the back of the printer, wait 20 seconds. Plug it back in.

13. IT WORKS AGAIN.

  SANTOS7 23:04 11 Dec 05

14. if all that don't work,whack it wiv a BIG Ammer...

  widdy 10:00 12 Dec 05

Thanks for your help, will give it all a try, even the hammer that is.

  Arnie 13:53 12 Dec 05
  Angry Kid 20:00 13 Dec 05

Try here....click here it may help you.

Angry ;-)

  widdy 17:28 08 Feb 06

thanks all round. after cleaning pads and pressing the buttons in the right order everything is working ok.

This thread is now locked and can not be replied to.

How to get Windows 10 for free | How to install Windows 10: There is still a way to avoid paying…

1995-2015: How technology has changed the world in 20 years

Hands-on with the Star Wars fighting drones you can fly yourself

15 macOS Sierra tips | How to use macOS Sierra: Secret tricks and best new features in Apple's new…