Continous Ink Feed- getting it down

  jack 12:06 28 Apr 08
Locked

The tubes.
The R 300 printer has been out of use for a while and as a result the ink in the supply lines has flowed back to the pots.
This has happened before and several 'Powerful Head Clean' cycles in the SSC utility has got them going again.
This time however it is being most reluctant to flow.
Any other ideas any one.

  jack 10:33 29 Apr 08

^^^^^

  jack 19:46 01 May 08

The way to get the ink flow in to remove the breather cap on the end of a tank and fit over it one of the refill syringes with the plunder pulled up.
A quick puff and all start slowing again.
But Beware sometime you can get a flooding from one or more nozzle so a few test prints would be advisable and tissue hand to mop up the pads.

This thread is now locked and can not be replied to.

The Legend of Zelda Breath of the Wild review: Five hours with Zelda on the Nintendo Switch

1995-2015: How technology has changed the world in 20 years

How the painting-like animated sequences in A Monster Calls were created by Glassworks Barcelona

The 22 best Safari extensions | Best Safari plugins: Improve Apple's Safari web browser with these…