Configuring optical drives

  Ian in Northampton 23 May 12
Locked
Answered

OK… Just got myself a new (secondhand) PC. It had a DVDRW drive in it, which was working fine. However, I had a Lightscribe drive knocking about that I wanted to install as well. Both are IDE drives.

First time I tried, I assumed that the existing drive was set to master. It was on the end of the IDE 80-pin cable.

I put it on the ‘middle’ output of the IDE cable, and connected the Lightscribe drive to the end of the cable

So I set the Lightscribe drive to be the secondary drive, assuming the existing drive would be set as the primary drive.

I booted the system, and it didn’t recognise either of them.

So I set the Lightscribe drive to be primary, but maintained the same position of the two drives on the IDE cable.

Now, the system recognizes the Lightscribe drive, but not the other one.

The situation is complicated by the fact that I can’t work out how to get the existing drive out to check the jumper settings – there are no retaining screws. Somehow, it seems to be ‘wedged’ in.

Now, in the back of my mind, I’m thinking that I remember that it’s important that the master drive is connected to a specific outlet on the IDE cable, and the secondary drive to the other one. I’m wondering if I’ve remembered correctly?

However, if that is the case, a further problem arises in that the IDE cable isn’t sufficiently long for me to do other than what I’ve done, and the drives themselves can’t go anywhere else.

I guess if I could get the existing drive out, I could rearrange the physical position of the drives such that the Lightscribe drive is nearer the motherboard and the existing drive is the furthest away – that way, I could connect the two drives differently. But, as I say, I can’t physically move the existing drive.

Anyone have any thoughts?

  onthelimit1 23 May 12

Master on the end, slave in the middle. There must be some screws somewhere - have you removed the other side of the case to check there?

  Fruit Bat /\0/\ 23 May 12

try setting your lightscribe to CS cable select and see if the two drives are recognised

Thanks otl. I'm guessing that the existing drive must be set to 'master' then - although, if it is, I'm surprised anything works (with two master drives). Yes, I've had both sides of the case off, and there are no screws - that I can see - holding the drive in place...

Fruit Bat /\0/\: how would I do that?

  Nontek 23 May 12

Two Master Drives is normal, providing each one is on a separate IDE cable.

Remove Jumper and reset as CS by looking at case of drive to see which is which - usually marked.

Nontek, thanks. Even if I can't read the markings (poor eyesight) I know that the one on the right is for master, the one in the middle for slave - so I assume the remaining one on the left is for CS?

  onthelimit1 23 May 12
  onthelimit1 23 May 12
  onthelimit1 23 May 12

Damn thing - just won't work for me as usual!

  onthelimit1 23 May 12

One last try!

here

Advertisement

This thread is now locked and can not be replied to.

Should I upgrade to Windows 10? 8 reasons why you should upgrade to Windows 10... and 2 why you…

We are being sold the ability to spend money we don't have. And we love it

IKinema aims to banish droopy shoulders and wonky spines in animated CG characters

How to use Apple Music in the UK: Complete guide to Apple Music's features

We use cookies to provide you with a better experience. If you continue to use this site, we'll assume you're happy with this. Alternatively, click here to find out how to manage these cookies

hide cookie message