Configure Hyperpen 6000

  Newby 17:06 14 May 09

I have just "dug out" my Hyperpen 6000 which I haven't used for 6 years.Acting on advise from Cable I bought a DB9 male to DB25 Male connector to connect my HP 6000 to the serial port. TCablrcity advised me when telling me that this connector would do the job but also said that I may have to configure start bits, stop bits, baud rate and parity. I have connected the hardware and installed the software - how do I carry out this configuration, please. Thank you.

This thread is now locked and can not be replied to.

Intel Coffee Lake 8th-gen Core processors release date rumours

1995-2015: How technology has changed the world in 20 years

Framestore’s haunting post-WWII title sequence for new BBC series SS-GB

How to install MacOS Sierra on an older Mac: Get Sierra running on Macs & MacBooks from before 2009