Should I upgrade to Windows 10? Windows 10 is now available, so do you have to upgrade? 8 reasons…
I’m having difficulty booting into Windows. When I switch my machine on it goes through the usual procedure of checking memory, then searching for hard drives. At this point the ‘Windows XP Professional’ logo appears, and for few moments the anticipation is that my Desktop will appear. Unfortunately not, the procedure then reverts to checking the memory over again in a circular motion. Your valued help please. Abel
Thanks Fruit Bat! I've tried the 'Last Known Good Configuration' bit, but still the circular reboot goes on. Please let me know how to do a repair install without losing my data.
Repair XP by install over the top of existing system
Boot the computer using the XP CD. You may need to change the boot order in the system BIOS so the CD boots before the hard drive. Check your system documentation for steps to access the BIOS and change the boot order.
When you see the "Welcome To Setup" screen, you will see This portion of the Setup program prepares Microsoft Windows XP to run on your computer:
To setup Windows XP now, press ENTER.
To repair a Windows XP installation using Recovery Console, press R.
To quit Setup without installing Windows XP, press F3.
- Press Enter to start the Windows Setup.
To setup Windows XP now and Repair Install , press ENTER.
DO NOT choose "To repair a Windows XP installation using the Recovery Console, press R", (you Do Not want to load Recovery Console).
Accept the License Agreement and Windows will search for existing Windows installations.
Select the XP installation you want to repair from the list and press R to start the repair.
Setup will copy the necessary files to the hard drive and reboot.
Do not press any key to boot from CD when the message appears.
Setup will continue as if it were doing a clean install, but your applications and settings will remain intact.
Many thanks for your instructions on how to do a repair install to my Windows XP OS. Firstly, I apologise for not dealing with the problem sooner which has been unavoidable. However, this-morning, having followed your instructions carefully the result is the comment ‘The partition is full, damaged or unformatted.’ This is certainly not the case regarding being ‘full’ or ‘unformatted.’ My HDD is 200 GB in two partitions each of 100 GB. The partition obviously damaged is the ‘C’ drive but the ‘D’ drive, on which I’ve backed-up my files with Acronis TI 9, appears to be OK. The question now is, is there any way of recovering the data, or a way of loading the OS on this drive and altering its title to ‘C’?
Boot to command prompt from the F8 menu and try a
ignore any messages that come up about losing data (you can't get at it at the moment anyway)
also worth trying
See if it will then reboot to windows.
Still no joy Fruit Bat. I kept pressing the F8 key while my maching was booting and got 'Windows Advanced Options Menu' from which I selected 'Safe Mode with Command Prompt' I assume this is the option you mentioned? The command prompt didn't show, instead I got continuous rows of Multi Disk something or other and after a short while the machine went into its circular boot mode again.
try going into your BIOS set up screen (often delete key on start up but it may be F1 or 2, or possible another depending on your motherboard) and tell your BIOS NOT to reboot upon error (halt on all errors), restart and see if you get an error message and post it back to see if someone will recognize it
'Safe Mode with Command Prompt'
No you just need command prompt.
Fruit Bat, there's no actual 'command prompt' option on the F8 menu only the one I mentioned.
lotvic, which of the BIOS menu items has the 'halt all errors' option in it. I've looked at them all briefly, with great trepidation in case I cause further problems,and I can't spot it.
Ok, then don't go into bios just yet, try this first: On the F8 menu, On the Advanced Boot Options screen, select Disable automatic restart on system failure.
This thread is now locked and can not be replied to.