Nintendo Switch review: Hands-on with the intuitive modular console and its disappointing games…
I have PC I use for work & recently have been having the following problem.
When I boot up it searches for the primary master drive but comes up as none & then wants to boot up from a floppy. If I go into BIOS setup it will find the drive, I press F10 to save the changes & boot again but still does not find the drive. Often if I keep trying it will eventually find the drive & boot up, then all works fine. I was advised to change the battery on the motherboard which I have done but it has made no difference.
Any help would be much appreciated!
OS- Windows XP - SP2
1400 AMD Athlon
Board- ASUS A7A266 1.10 socket A
1024 MG RAM
HD – Fujitsu 40G
i had the same problem in that it would sometimes
detect hard drive but sometimes not
on this forum i was told that sometimes a computer can boot up so quickly that your hard drive is not ready
so in bios switch on memory check if there
also tell bios to floppy seek and put the floppy
drive as first boot and hard drive as second
this solved my problem
So I have just tried the PC to check malgall suggestions & guess what it boots up first time!
I'm not sure if the memory check is on but I do know that the floppy is first. Is there anything I can check through Windows?
Diodorus Siculus thanks for your reply, I did think about the hard drive, but why does it work sometimes??& yes you are right mid 2001 I got the PC, hence its now just used for work!
As drives get older, sometimes they take longer to get completeñy up to speed and become ready (ie available). This can then on occasions exceed the time it takes for the booting to look for the drive - so it doesn't find it. That's why the solution is often to make the initial part of the boot take longer, by enabling the longer memory test, and/or making the system look for the floppy drive first. Some BIOS even have a facility to put in a delay before the hard disk is checked.
PC has been running fine for a couple of hours or so now so I thought I'd do a restart & guess what the HD is not found, although it is in the BIOS setup!
Here's the options I have in my BIOS setup.
Plug & play OS - no
Reset configuration data - no
boot virus detection - enabled
Quick power on self test - enabled
boot up floppy seek - enabled
These are all the default settings.
Change the *quick power on test* to disabled - this gives a longer test (ie it disables the quick one, and runs the regular - slower- one).
See if this helps.
If you are running XP plug & play OS should be set to yes.
Not that this will be cause of the the problem.
That seems to have worked! Although the memory test appears to go on a loop until I tell it to skip, but I do get asked what drive I want to boot from & the HD was found! Does this all point to a problem with the HD & would a new drive solve the problem completely?
Thanks Fingees I thought on XP it should be set to yes, old PC! As you say not the cause on the problem!
It probably isn't in a loop - it generally runs through the memory some 3 times or so - so just leave it and it should finish.
Yes it is a sign that the hard drive is playing up - though they can last a long time in this state. Whether you risk it or get a new one is down to the usual reasons.
Thanks DieSse I'm now busy backing up all the data! Think I will probably just replace the drive. I don't need a large HD on this PC, 40G is more than enough so for the cost involved not worth taking a risk. I just didn't want to replace the drive if this wasn’t the problem!
This thread is now locked and can not be replied to.