Base unit will not switch on

  Alastrina 13:09 18 Feb 10
Locked

I have a Packard Bell base unit, only 9 months old with windows Vista. Was fine yesterday but when i went to switch it on today, it wurrs for 2 seconds and turns off. I have removed all the hardware attached and just put the neccersary hardware and leads back in but it still does the same. Has the PSU gone? Thanks for any help you have.

Alastrina

  MAJ 13:30 18 Feb 10

The PSU is one (the most likely) possibility, Alastrina.

  ame 13:40 18 Feb 10

I bought an external hard disk that did that from brand new.

  Alastrina 14:15 18 Feb 10

Before I replace the PSU, what other likely causes are there that I can try?

  oldbeefer2 14:35 18 Feb 10

Take it back, would seem the obvious route to go as the basic warranty is 12 mths.

  ame 15:40 19 Feb 10

Agree with oldbeefer2 - you'll screw up the warranty if you go mucking about inside.

This thread is now locked and can not be replied to.

Nintendo Switch review: Hands-on with the intuitive modular console and its disappointing games…

1995-2015: How technology has changed the world in 20 years

Method Studios' title sequence for BBC series Taboo is truly unsettling

Best Pages for iOS tips | How to use Pages for iPad & iPhone: 7 simple tips to get more out of…